PhalloBoards - An Online Community to Discuss Penile Girth Enhancement

Welcome, Guest
Username: Password: Remember me

TOPIC: Avanti PMMA - Round 1 April 2024

Avanti PMMA - Round 1 April 2024 7 months 5 days ago #1308717056

5 days post procedure

Here’s the shape I’m in now. Still got some swelling at the neck and what I hope is swelling on both sides towards the base (you can see it more in second pic). Also lots of fluid in my scrotum.

1st pic Erect
2nd pic Erect with Red Bull can that is ~5.5”L and ~6.4” circumference.
3rd pic Flaccid.

Flaccid midshaft is 5.5”
Flaccid base is 6.75” with the swelling.

Another note: my previous bone pressed Flaccid stretch length was 18.2cm. Right now it’s 17.0cm. Perhaps all the material in there is making it harder to pull akin to trying to take a BPFSL measurement with a semi-Erection? I’m not sure.

Erect measurement later - kids just woke up lol.
Attachments:
  • HA dermal fillers comparison.jpg
The following user(s) said Thank You: Jung

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 3 weeks ago #1308717153

2 week update

I think the swelling is gone or mostly gone and I’m entering the collagen building phase. I feel a slight itching sensation here and there that I’d compare to the itch you get when you shave your unit and the hair grows back. Anyone experience this?

As far as aesthetics, there is lumpiness which you can see in second picture of the previous post. Just slightly above the base there is a buildup of filler that flairs out to the side then runs down the shaft. I think @SoonDigBick described something similar. It’s even more apparent from the side and bottom view. Also, I have filler at and above the circ line that is very palpable. So these high spots paired with less material midshaft makes for a very lumpy feel in the hand and visually. I hope this doesn’t read as me being dissatisfied - I expected to do at least another round whether that be a full session or touch up and communicated as much to Dr Morales to give her the freedom to focus on girth over aesthetics for this round.

Next phase for me is to let the collagen building phase to run its course then consult with @Avanti_Derma on whether I need a full round or touch up.

As of right now girth erect measurements are:
Neck: just shy of 6”
Midshaft: slightly above 5.5”
Base: 6.25”

Coming from a mostly uniform 5” girth. I’d be pretty happy to keep this size while bringing up that midshaft numbers to correct the visual and tactile lumpiness. Any initial thoughts on if a touch up is enough to correct or if a full round is in order?
The following user(s) said Thank You: JJones928

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 3 weeks ago #1308717154

  • Jung
  • Jung's Avatar
  • Offline
  • Pending Email Verification
  • Pending Email Verification
  • Posts: 107
  • Thank you received: 32
I think you said it yourself to answer your question.

"Next phase for me is to let the collagen building phase to run its course then consult with @Avanti_Derma on whether I need a full round or touch up."

You got several more weeks to go before you are in much of a position to have certainty on what to do next.

Keep the course.

Please Log in or Create an account to join the conversation.

Last edit: by Jung.

Avanti PMMA - Round 1 April 2024 6 months 3 weeks ago #1308717155

The itchy is collagen building happen everytime nothing to worry about go for round 2 for aesthethics like i did with all 10%

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 3 weeks ago #1308717157

Thanks for your input @Yup and @uncuthero .

I don’t mean to get ahead of myself, rather I’m curious about touch up rounds because I haven’t found as much discussion on that in terms of yield, how much it can actually correct etc whereas we have really good data on what to expect from a full round. Also there’s the cost implication though I’m financially prepared for either procedure during round 2.

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 2 weeks ago #1308717277

  • Jung
  • Jung's Avatar
  • Offline
  • Pending Email Verification
  • Pending Email Verification
  • Posts: 107
  • Thank you received: 32

itgoesthud wrote: If you're a megaturtler like me, this is something that might be worth investigating in advance of your trip:
phalloboards.info/forum/dr-casavantes-dr...very.html#1308715525

I have a practitioner nearby that does "Bocox", which I plan to do in advance of any PMMA trip.


How much does BoCox cost?

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 2 weeks ago #1308717278

Yup wrote: How much does BoCox cost?


funny enough i turned on AI results for google and it actually scd original source content to give me prices; seems to be about $10 per unit, most people do 50-100 units (I'd do 100) so about a grand just for the botox. A lot of them are also pushing PRP in addition, that's probably another $1000-$1500.
If the joint up the road from me asks $2k for just the botox I'd be more than amenable, and get it done 2 weeks before an Avanti procedure.
The following user(s) said Thank You: Jung

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 1 week ago #1308717355

4 Week Update

Neck: 6”
Midshaft: 5.75”
Base: 6”

Note: measured this AM with morning wood and did have sex last night (some possible swelling) so these were favorable measurements.

The neck measurement seems to have remained consistent from week 2, whereas midshaft is up approximately .25 Inch. At the base I’m down .25 Inch from week 2 which I’m happy about since I had a bit of bulging on the underside which made for a lumpy feel.

I’ll continue to monitor as time goes on but thoughts at this time as far as goals for round 2 would more filler in the midshaft for more uniformity which would lend to a more natural aesthetic. Also there is a very apparent cliff at the neck before the glans that I hope to address.

A note regarding condoms. I bought Magnum XL, Durex XXL, and Skyn Elite Large. So far I’ve tried the Magnums and they were a struggle to get on. I had to unroll the condom then insert two fingers from each hand to stretch it over the neck then roll the condom on. Very restrictive at the base where the Magnum tapers, which reminded me of a Cock ring.
The following user(s) said Thank You: ou812

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 1 week ago #1308717361

Yep, if you don’t go custom the durex xxl is your best bet…… and it will still be TIGHT.
The following user(s) said Thank You: richardgaines

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 2 days ago #1308717457

  • Jung
  • Jung's Avatar
  • Offline
  • Pending Email Verification
  • Pending Email Verification
  • Posts: 107
  • Thank you received: 32
Can we get some updated pics, please?

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 2 days ago #1308717460

Sure thing @Yup

Just over 5 weeks since procedure

I sent these pics to Avanti to inquire about next steps.

Pic 1: about 90% erect. For those without premium access, I’m 6” or a hair over at the base, then about 5.5” midshaft, then a hair under 6” just at and above the circ scar. I was previously at a uniform 5-5.1” erect.

Pic 2: semi flaccid, showing the under/side profile where there’s a dip. From top view it may not look like it’s a full .5” thinner than the base so I wanted to illustrate where I could use more filler.

For reference I’m just under 6.5” BPEL but got a decent fat pad putting my non-BPEL at 5.25”. Also note that round 1 was a girth focused round where I received 18cc of 30% and 3cc of 10% (mostly above circ scar IIRC).

Next steps: a smoothing session won’t provide enough volume to even out the midshaft so full round it is. Also I want to taper the neck better as the cliff is very prominent especially when I’m at max hardness. Just need to plan and schedule the trip.

Another note, sex has been ridiculously good. No regrets at all.
Attachments:
  • HA dermal fillers comparison.jpg
The following user(s) said Thank You: Avanti_Derma, Jung

Please Log in or Create an account to join the conversation.

Last edit: by richardgaines.

Avanti PMMA - Round 1 April 2024 6 months 2 days ago #1308717461

  • Jung
  • Jung's Avatar
  • Offline
  • Pending Email Verification
  • Pending Email Verification
  • Posts: 107
  • Thank you received: 32
Thank you for your quick and thorough response!

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 2 days ago #1308717465

Richard i think you will benefit from a 10% PMMA entire procedure
The following user(s) said Thank You: richardgaines

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 6 months 2 days ago #1308717467

Thanks @uncuthero ! Been following your journey and it’s great to see the massive (haha) improvements you’ve experienced so this is something I’ll definitely bring up with Dra. Morales and Ian.
The following user(s) said Thank You: Avanti_Derma

Please Log in or Create an account to join the conversation.

Avanti PMMA - Round 1 April 2024 5 months 4 weeks ago #1308717510

Round 2 booked for August which will put me at 15 weeks between sessions. Game plan as far as prep goes will include PE by way of extending and pumping, and to drop some weight. Would like to get the fat pad down and close the delta between BPEL and non-BPEL but I’m aware that losing fat in the pubic region is a slow go.

Please Log in or Create an account to join the conversation.

Moderators: hoddle10bricebdstern22NoxcuseTexasDream