Nice gain man , dont worry about the ring, most of it will be corrected in the 2nd session but I am interested to know some points :-
1- As far as I remember you had 18 cc 10% for the shaft and then you have noticed the gap rt behind the glans and Dr.C. injected another 3 cc in this area but it was 5%. Correct
Is that the area (the ring) where (5%conc.) has been injected ?No- the 5% was place just under glan above the ring.
2- Does the ring feels softer or firmer than the rest of the shaft ? It is slightly firmer. I believe my ring is larger than usually because I have a crazy vein that goes from rt to lft rt where the ring is.
3- IMO to solve or reduce this problem in the future is when they wrap the penis it should be wrapped a bit tighter (only in this area for more compression) than the rest of the shaft, @whattime if you could bring these pictures with you and show Dr.C. and ask him about this point, please.I dont know if the ring issue can be avoided for some. My ring was pretty immediate. Dr C said the 10%
PMMA wouldnt stay rt below my glans and kept pushing it back. Plus Wade stated I have a lot of extra skin which is good for the final outcome but usually mean a larger ring. So What I am saying is I think the ring outcome is based on you genetics ie penis, skin etc.
I think the skin in this ring area is usually looser than the rest of the shaft so it could be the reason or it could be there is some movement of the
PMMA due to gravity in the 1st 24 hrs so by compressing (mildly) this area (before wrapping the whole shaft) with the bandages or (with steri-streps) more than the rest esp. in the 1st 48 hrs will reduce this ring issue (IMO). I dont believe its gravity. I think that when he injects rt below the glans it either stays or it gets push back and it accumulates where it can-- the loosest softest skin which is rt above the circ scar for most.
bigwheels, as I said before dont worry I am sure Dr.C. can easily correct this problem :- he can easily inject proximal to the ring (the shaft) without any problem but the most important is to inject a small amount distal to the ring just to taper it (between the glans and the ring) and I am sure in your case the skin in this area (in front of the ring) is not so tight in
Flaccid. I am hoping he will inject more
PMMA rt below glands and then shrink the ring just a bit. I think that if he does that it will be tapered just rt.
Good luck