Ya the first night I measured .5” thicker and today I’ve lost .25” of that so I’m currently .25” thicker on day 2 (25 hours post op)
Last night I could see the gel and I was struggling to move it at all. But I had one session of heating up a towel and it was a little hotter than my other sessions. I left it on for about 15 minutes. I lifted it and could feel my penis being very warm so I went and hopped in a warm shower and began to massage with soap (recommended by the doc)
During this heat and massage session I was able to actually move the gel. I was able to get hard and move the gel towards the base and towards the circ scar - both places were basically void of any filler.
When I woke up today I was the same size as pre-op and immediately thought “did I melt the gel?”
As the day has gone on I’ve gained roughly .25” back but idk if that’s just swelling or what not - either way I wasn’t expecting to have little to no gain off the bat after that many syringes. But I was told to not care about size until around the 2-3 month mark when collagen begins to form so I’m just hoping for the best.
My theory is 2 things
1. when I made the gel more maleable - and got a boner - I think I spread the gel out pretty evenly around my entire shaft and by doing so it doesn’t look like there’s any filler in there. It’s just even all around and maybe that’s why it hasn’t gained much size from just the
Bellafill.
2. This one has just been a concern all day as this is my first time ever doing it and I don’t know how hot too hot is when doing the rags and shower and what if I melted the
Bellafill and over night it migrated somewhere which I hope not. Would there be any signs of that?
My
Foreskin was really swollen from inflammation. I didn’t get any syringes there unless he put the prp shot there. But now my
Foreskin is bruised and black underneath - is this normal?