Today, I completed a third, smaller round. I also did a p-shot. I felt like, as I'm guessing many of you have felt, I just want a little more uniformity and just a bit more size. Before this round, I was 5.5
Girth. I had a couple uneven spots. It's probably the perfectionist Virgo in me but, wherever I see the smallest of imperfections, I want to fix it. I know, over time, these even out. But, I've felt lower fill areas where it just needed a bit more. So, today I did just that.
I had some gaps, on my left side, near the base, and on my right side, near the midshaft. We added two mills right near the base on the left and another mill on top, again near the base. Another mill was added mid-shaft on the right side. Honestly, I think I can still add a mill or two on the my left side near the base. You can see in the photos, there's still a bit of an indent.
I also decided I wanted to try and fix some of the
Turtling by getting some filler in the glans. My thinking is, perhaps with a bigger crown, my "
Grower" won't look like a
Flaccid, under-
Circumcised penis and the skin would better rest against the larger crown. I also felt like my head looked unnaturally small relative to my increased shaft
Girth. Two mills were added, using a blunt canula, on the crown. They go in from the outside edge, start the fill at the half way/ center point and draw filler back toward the outside edge. Then, they go to the other side and do the same. Finally, one mill of micro-injections were "fanned" off the crown, using a small needle. This is to reduce the curve from the increased crown size.
One thing that startled me was the amount of blood that practically gushes from the injection points on the crown. Since this area is so sensitive, despite being numbed up, I could feel it - not as bad as the p-shot! (which was six injection points on the shaft that had new squirming just a bit). The other is the amount of bruising. Right now it looks angry. I'm glad I waited and saw what my eventual
Girth would be. I'm also glad I've previously seen, thru the bruising of round 1 on the shaft, just how that healed up fine. So, I'm not as alarmed by the dark trauma on the head tonight. I'm definitely icing the glans though!
With the combined three rounds, I've now had 27 mills of filler- between shaft and glans. It sounds like a lot but I am 7.5 and it simply seems to take a lot to get the 3/4
Inch added
Girth I wanted. I'm going to let this settle in for awhile and simply enjoy the reaction. But, I've not discounted the idea of adding just a couple more mills to the left side near the base. It's still just looking a bit uneven. I'll update again, in a couple weeks, after I've healed up with additional photos.