First week in October, went in for round 2, this time with a little experience, greater excitement, and lower level of anxiety. I opted to fly in/out same day since my flight is a little over 1 hour, and had no troubles with the travel. One key learning from this trip is the need to be very clear with Christian about appointment time and confirm it upon entering the office - I sat in the waiting room for 4 hours and there was concern about border traffic and making it to airport in time because of appointment management. So, on to the main point, the actual procedure.
PRE PROCEDURE:
Had a good pre-meeting with Wade and Dr.
Casavantes where they listened to my input, inspected the work area. They recommended 20% METACRILL and talked me off the edge of fear regarding lumps and achieving a natural looking/feeling penis.
PROCEDURE:
I agreed and the prep work began. The area was cleaned/disinfected, anesthesia administered (again, no pain at any entry point), area marked out by Dr.
Casavantes, and within 20 minutes, the
PMMA was being pumped in.
In the first round, the key objective was to get the shape and add a little size, this round was about size, filling in the CS area as i had a significant gap between the CS and Glans. This by the way was the most anxiety inducing point of the whole experience as some of us have the skin that take the
PMMA up to the Glans and others, not so much. Wade explained that if I could not take the
PMMA up to the Glans because of my skin, that the overall volume would be reduced and that it would limit the
Girth unless I was willing to accept a higher degree of tapering. Lucky for me, I took the
PMMA fine.
Next part of the job, filling in a gaps behind the CS and at the base. Another point where I was a little concerned is I had 2 spots that felt hard. For guys that have not had the procedure the best i can explain is imagine running your finger down the length of your shaft and coming to a point where it feels like there is a ridge of harder material maybe like chicken cartilage. Wade explained the process of poking through the \'hard-spots\' to break them up and fill with 2nd round of
PMMA. Happy to report that 4 weeks after round 2, the hard spots are gone.
We got to the point of 30cc and no material was leaking out of the incision points and though my penis could have taken more, Dr.
Casavantes suggested we stop as his confidence in managing the results above 30cc\'s starts to diminish and, my idea/attitude is risk mitigation, much rather come back for another round then take the risk for a little extra gain. Wade found a few spots that needed a little more fill and additional 4cc\'s was injected bringing total procedure to 34cc\'s.
POST PROCEDURE:
Within the first 24 hours, I was at 7 1/4\" with the swelling and after 48 hours, the swelling subsided and I ranged from 6 7/8\" to 7 1/8\" pending time of day, level of arousal, etc. I experienced no
PMMA material loss and the entrance points were closed.
By day 3, no irregular coloration from bruising, and my wife and I were eager to try it out. we started with oral and she immediately commented on the size and that she felt a little constrained with what she could do to me orally as it was all she could do to get it in her mouth. Lucky for inner-monologue as I didn\'t say anything foolish about the size of her mouth that would end the session .
Then it came to vaginal sex which she found the size to be uncomfortably large but happy to report she is not a quitter and after slow warm up and lots of lube, she found it enjoyable but something she would have to get used to vs. round 1 where she was euphoric. We think that end state of 6 1/4\" to 6 1/2\" is the ideal
Girth for her so now it is a matter of time to see where we actually end up.
Attached are some pictures and measurements below:
1 month post procedure:
Flaccid:length - 4\"-5\" glans - 4 1/4\"CS - 6 1/2\" to 6 7/8\"mid - 6 3/8\" to 6 1/2\"base - 6 3/8\" to 6 1/2\"
Erect:length - 6\"glans - 4 1/4\"-4/3/8\"CS - 6 5/8\" to 7\"mid - 6 1/2\" to 6 5/8\"base - 6 1/2\" to 6 5/8\"
Wade suggested our next steps; give rounds 1 and 2 a little time to settle and in January 2013 decide if there is any additional work to be done. At this moment in time, I would opt to start enhancing the length as my
Girth is now equal or larger than my length which makes it appear shorter. But, I am not making any decisions until January and just going to enjoy the results of round 1 and 2.
With that, I will leave you with a Halloween story. My wife and I attended a party at a swingers club and a lady approached me and asked me \'is that all you down there?\' - I have never been asked anything like that before. And later in the night, my wife took me up to one of the group play rooms and we went at it. She was happy to show off the goods and she let all of us at the party know it - that alone was worth the ~$5k spent so far. I\'ll check back in January and let you know where this goes. Until then, happy holidays to all of you.