Hey all,
Fairly new here and loving the advise and honesty of all that contribute.
I recently bought the Phallosan forte yes I found it slightly cumbersome but then I think most devices are by there very nature. I think I’ve tried them all over the years. The Phallosan, I think is definitely the easiest to wear for long periods of time, which is obviously important.
By the way I will upload a video or photos later. Right now it’s on and I don’t want to disturb him while he’s busy working.
1. The sleeve that is attached to the bell, that the company advise to roll down and then over the rim of the bell, I find cumbersome.
2. What I do is, similarly to when applying the glans protection cover, I place my pointer finger and middle finger of both hands into the sleeve pull wide apart and let my penis drop into the space. I’ve also had the idea of trying this step without the bell, applying it next. I will test this and update.
3. Once penis is in the sleeve, let the area of sleeve closest to the top of penis, near bell opening retract and grip the shaft and slowly
Inch your finger out.
4. Some overlapping can occur at the base as you try to remove your fingers, which I suspect I’ll get better at preventing overtime. This needs to be corrected as I assume would add unnecessary additional force which could interrupt blood blow and cause pain. Carefully pinch the sleeve and adjust to leave a flat sleeve.
5. Now resume with the pumping and suctioning as normal.
I found this method far easier and produced a better sustainable suction.
I am pre PE procedure, although am planning to have done soon. Not yet sure of my plan for post procedure,
Enjoy guys.
As I said, will upload video or photos, what ever I can manage while both hands will obviously be very busy.
Mega.
